Barbed Wire Arm | 2-3/8" x 2-3/8" | 3 wire | 45° angle

45 degree angled barbed wire arm for 60 x 60 mm posts, three wires

This barbed wire arm is made for square fence posts with a 60 x 60 mm section. It fits on the top of the post and holds three lines of barbed wire above the fence, so the barrier becomes higher and harder to climb over. The arm is angled at 45 degrees, so the three wires sit at a slant above the fence line rather than straight up.

Sizes and fit

The arm takes a square post of 60 x 60 mm. Check the outside dimensions of your posts before ordering. For a post of 76.2 x 76.2 mm, choose the 76.2 x 76.2 mm arm instead. Fit one arm on every post in the run, so the wire is supported along the whole length of the fence.

Colors

The arm comes in moss green RAL 6005, fir green RAL 6009, anthracite gray RAL 7016, black RAL 9005 or an aluminum finish. Order it in the same color as the posts and panels for a uniform look along the fence.

Typical uses

Barbed wire arms are fitted where the top of a fence needs extra protection, such as around business premises, storage yards and other closed sites. They turn a standard post into a support for barbed wire without changing the fence below.